Sensor Holders

Parts can usually be made locally. Search for 3D printing (my city). It should turn up a list of local printers. Prices may range from low 10’s to close to 100’s depending on the size and materials used.

3D CAD files for Target Holder

Club Target Holder

Value engineered solution for clubs. Basic target holder that lets you have multiple lanes without breaking the bank

Club Target Holder

Competition and Home Target Holder

Full features with witness paper driver and LED illuminations. Build with and without the witness paper drive as needed

AutoDesk Fusion 360 CAD file. Unzip to use

Arduino Base

Install the Arduino into your target holder with this base plate. Provides mounting studs and USB cable strain relief

Arduino Base

Arduino Cover

Plastic cover to protect the circuit

Sensor Base

Single assembly that holds all of the sensor at the correct distance apart for a Pistol Target

Sensor Base

ESP-01 WiFI Mount

Simple pad to securely attach the ESP-01 for WiFI applications

ESP-01 WiFI Mount

Sensor Mount

Sensor mount that attaches to the sensor base. Print four for each target.

Sensor Mount

Face Sensor Mount

Face sensor mount that connects the microphone to the face plate while shielding from ambient sounds.

Needs V3.8.3 or higher

LED Strip Attachment

Holds the LED strip securely in place. Print 12 recommended

Light Clip

Download the zip file below which contains the STL files for each of these pieces.

Extract the part you need and print it yourself, or send it to a service bureau.

Sensor Cover

Small plastic cover to protect the circuit

Simple Piece Parts

This selection is the basic parts needed to hold the target and mount the sensors onto your target holder

Clip On Package

Simplifies assembly by using clips to attach the target holder to the sensor mounts

Clip On Parts

Quarter Sensor Mount

This is an integrated part that combines the sensor mount with a jig to ensure that the spacing and alignment are correct.

  • Print out four of these
  • Glue the four parts together

For the first three pieces, do one joint at a time, and clamp. Glue the two joints for the last piece at the same time. Be careful when clamping that the joint being glued doesn’t buckle

  • Centre the desired target between the sensors and use this as a template to position the target holder pieces to the frame. Glue and clamp these to the other side.

Steel Target Face

These are rectangular steel plates used to mount the target and protect the sensors. When installed on the sensor modules, the target is 10mm from the sensors.

Blank plate that lets you locate the mounting holes in a convenient place

Air Rifle Target Plate

Target frame

Frame for the sensors on one side and SIUS paper mask on the other. The holes correspond to the SIUS mask mounting holes. 4 small bars in the holes will secure the masks in place.

sensor side
target side